TRAILHEAD SUPPLY

As horsemen ourselves, we know how worrisome it is while trailering our horses.

After years of developing and testing, we believe Trailer Eyes TE-0408 wireless monitoring system is the most user friendly device on the market to monitor valued cargo in trailers.

There is no need to drill holes in your trailer. No tools required. Trailer Eyes TE-0408 can be set up in 5 minutes. Other than a 9V battery, everything you need to set up the system is included in the box. (The 9V alkaline battery can be purchased in just about every gas station or grocery store.)

A single alkaline 9V battery can operate the camera up to 5 hours during the day or 3 hours in night vision mode.

Here is what included • Wireless color camera with night vision • 3.5" color screen monitor • Booster antenna with magnet base • Standard antenna • 12V car lighter power adapter • Goose-neck windshield suction mounting base for the monitor

Here is how it works-

To set up the camera in your trailer-- 1. Use the clamping base to mount the camera. The clamping base can be clamped on any pole or board which is less than 2 ¼” in diameter or thick. Choose the mounting spot and tighten the clip bolt on the clamping base. 2. Loosen the tilt lock knob, adjust the camera , point it in the direction where you wish to monitor, and tighten the tilt lock knob. 3. Insert a 9V battery. Turn the On/Off switch to the ON setting. A single 9 V battery can operate the camera up to 5 hours in day time, 3 hours under night vision mode. ( Rechargeable 9 V Lithium Ion battery are available.)

The camera is set!

To set up the monitor in your pulling vehicles-- 1. Mount the goose-neck suction mount to the windshield, dashboard, or window. 2. Attach the monitor to the goose-neck suction mount. 3. Attach the antenna connector to the monitor. 4. Open the car door and mount the booster antenna (magnet base) on the side of your vehicle. Run the wire between the antenna and the monitor through the car door and the car frame, not through the car window and door frame. 5. Plug the power jack into the monitor, and then plug the 12V car lighter adapter into the lighter jack. 6. Turn the monitor on. 7. Adjust the position of the monitor, the antenna wire, and the power wire to avoid interference with the driver.

We are confident to say, Use it once you'll want it for every trip! With optional adapters,it can be easily converted to a barn cam or foaling monitor.

Optional adapters for Trailer Eyes®

The following three items are not included in the Trailer Eyes box. These are the optional adapters , you may use them to run Trailer Eyes from different power source.

TE-0408ADP-12V --- 12 V DC to DC adapter, With this adapter, You may use the power from your trailer's lighting system to run Trailer Eyes'camera (Installation is required , trailers are various, we do not provide installation instruction. Your local trailer dealer will know how to install it.)

TE-0408ADP-CAM --- 110 V AC/DC adapter for camera. With this adapter, you may use the Trailer Eyes' camera from any 110V power source (No installation required).

TE-0408ADP-MON --- 110 V AC/DC adapter for monitor. With this adapter, you may use the Trailer Eyes' monitor from any 110V power source (No installation required).